[CMD]
Send commands to the 2AP and display the responses=Send commands to the 2AP and display the responses
Syntax=Syntax
port baud=port baud
where=where
port is 1 for com1 or 2 for com2=port is 1 for com1 or 2 for com2
baud is chosen from=baud is chosen from
Alternative Syntax=Alternative Syntax
parameters are taken from the configuration file=parameters are taken from the configuration file
no parameters are required.=no parameters are required.
defaults are com1, 1200 baud=defaults are com1, 1200 baud
WARNING=WARNING:  This is a low level utility.  Using this utility you can modify 
WARNING2=the calibration and equipment configuration information.
A null input line will terminate this program=A null input line will terminate this program
[Exceptions]
[Version]
[Ini]
[2apSerial]

[Errors]
'%s' not found in block [%s] in file %s='%s' not found in block [%s] in file %s
%s v%ir%i as read from a stream does not match %s v%ir%i=%s v%ir%i as read from a stream does not match %s v%ir%i
%s file not found=%s, dat file not found
Syntax error in %s in the text %s=Syntax error in %s in the text %s
timeout=timeout
Invalid password=Invalid password
Communications error=Communications error

NO 1=framing error
NO 2=time out
NO 3=unrecognized command
NO 4=message too long
NO 5=undecodable parameters
NO 6=queue full
NO 7=bounds exceeded
NO 8=max vel exceeded
NO 9=max acc exceeded
NO A=autonomous
NO B=invalid adjustment size
NO C=invalid total adjustment
NO D=duration out of range
NO E=unavailable analog point
NO F=illegal extant
NO G=password protected
NO y=hardware failure
NO z=illegal firmware state
; internal 2apserial
transmission too long=the transmission from the tracker was too long... probably a communications error
undecodable response=response could not be decoded... probably the FED code was wrong
invalid password=could not communicate with tracker, the password is incorrect